This article applies to the following ScreenBeam products:
+ 
1100 Plus and Shared AV Devices
This configuration supports both wired and wireless Bring Your Own Meeting (BYOM).
- Wireless presentation and video conferencing with ScreenBeam Conference
- Wired presentation and video conferencing with HDMI & USB cables
Hardware Requirements
- ScreenBeam 1100 Plus version 11.1.12.11 (or later)
- ScreenBeam USB Pro Switch
- All-in-one USB video bar
Wiring Diagram
Wiring Connection Steps
On the USB Switch
- Connect the USB cable from the video bar to the USB Switch Device port
- Make sure the video bar is connected to its own power supply
- Connect the USB Switch Host Input 1 port to the 1100 Plus using the USB cable provided with the USB Switch
- Note: Please select the USB 2.0 port next to the power supply
- Connect the second provided USB Cable to the USB Switch Host Input 2
- Note: This USB cable is designated for the BYOD computer
On the 1100 Plus
- Connect the HDMI cable from the display to the 1100 Plus HDMI Out port
- Connect another HDMI cable to the 1100 Plus HDMI In port
- Note: This HDMI cable is designated for the BYOD computer
Related Articles
- ScreenBeam 1100 Plus firmware
- ScreenBeam USB Pro Switch Quick Start Guide
- Setup Guide - Camera for ScreenBeam + MTR
- Setup Guide - Touch for ScreenBeam + MTR
- Setup Guide - Camera and Touch + MTR
- Tips & Notes - USB Pro Switch
Comments
0 comments
Article is closed for comments.