Articles in this section

Setup Guide - Camera for ScreenBeam + MTR

Mike T
  • Updated
Follow

This article applies to the following ScreenBeam products:

1100 Plus   +   USB Switch

1100 Plus with Teams Rooms and Shared AV Devices

This configuration supports Teams Rooms meeting and wireless Bring Your Own Meeting (BYOM).

  • Teams Rooms video conferencing
  • Teams Rooms with wireless display via ScreenBeam
  • Wireless presentation and video conferencing with ScreenBeam Conference

Hardware Requirements

  • Microsoft Teams Rooms PC or equivalent UC system
  • ScreenBeam 1100 Plus version 11.1.12.11 (or later)
  • ScreenBeam USB Pro Switch
  • All-in-one USB video bar

 

mceclip0.png

Wiring Connection Steps

On the USB Switch

  1. Connect the USB cable from the video bar to the USB Switch Device port
    1. Make sure the video bar is connected to its own power supply
  2. Connect the USB Switch Host Input 1 port to the in-room PC using the provided USB cable
  3. Connect the USB Switch Host Input 2 port to the 1100 Plus using the USB cable provided with the USB Switch
    1. Note: Please select the USB 2.0 port next to the power supply

On the 1100 Plus

  1. Connect an HDMI cable from the 1100 Plus HDMI Out port to the HDMI Input of the MTR Controller such as a Logitech Tap 

Additional Considerations

  1. Configure the 1100 Plus HDMI Port Power Management setting to ScreenBeam USB Pro Switch
    1. This sets the ScreenBeam HDMI Out port to turn off immediately so the MTR screen can be seen on the display
    2. The ScreenBeam HDMI Out will activate upon a connection attempt from the user
  2. Consider customizing the MTR background image to include the ScreenBeam receiver name (i.e., room name)
  3. Wired presentation can be supported if by adding an HDMI cable to the 1100 Plus HDMI In port

Related Articles

Comments

0 comments

Article is closed for comments.