Articles in this section

Setup Guide - Touch for ScreenBeam + MTR

Mike T
  • Updated
Follow

This article applies to the following ScreenBeam products:

1100 Plus   +   USB Switch

1100 Plus with Teams Rooms and Shared Touchscreen

This configuration supports Teams Rooms meeting and wireless touchback 

  • Teams Rooms video conferencing
  • Teams Rooms whiteboard collaboration using touchscreen
  • Teams Rooms with wireless display via ScreenBeam with wireless Ghost Inking
  • Wireless presentation and wireless Ghost Inking with ScreenBeam

Hardware Requirements

  • Microsoft Teams Rooms PC or equivalent UC system
  • ScreenBeam 1100 Plus version 11.1.12.11 (or later)
  • ScreenBeam USB Pro Switch
  • All-in-one USB video bar
  • Touchscreen monitor

Wiring Diagram

mceclip1.png

Wiring Connection Steps

On the USB Switch

  1. Connect the USB cable from the touchscreen display to the USB Switch Device port
  2. Connect the USB Switch Host Input 1 to the in-room PC using the provided USB cable
  3. Connect the USB Switch Host Input 2 to the 1100 Plus using the provided USB cable

On the 1100 Plus

  1. Connect an HDMI cable from the 1100 Plus HDMI Out port to the HDMI Input of the MTR Controller such as a Logitech Tap 

Additional Considerations

  1. Configure the 1100 Plus HDMI Port Power Management setting to ScreenBeam USB Pro Switch
    1. This sets the ScreenBeam HDMI Out port to turn off immediately so the MTR screen can be seen on the display
    2. The ScreenBeam HDMI Out will activate upon a connection attempt from the user
  2. Consider customizing the MTR background image to include the ScreenBeam receiver name (i.e., room name)
  3. Wired presentation can be supported if by adding an HDMI cable to the 1100 Plus HDMI In port

Related Articles

Comments

0 comments

Article is closed for comments.