Articles in this section

Setup Guide - Camera and Touch for ScreenBeam + MTR

Mike T
  • Updated
Follow

This article applies to the following ScreenBeam products:

1100 Plus   +   USB Switch

1100 Plus with Teams Rooms and Shared Touchscreen and AV Devices

This configuration supports Teams Rooms meeting, wireless touchback, and wireless video conferencing

  • Teams Rooms video conferencing
  • Teams Rooms whiteboard collaboration using touchscreen
  • Teams Rooms with wireless display via ScreenBeam with Ghost inking
  • Wireless presentation with Ghost inking and video conferencing with ScreenBeam Conference 

Hardware Requirements

  • Microsoft Teams Rooms PC or equivalent UC system
  • ScreenBeam 1100 Plus version 11.1.12.11 (or later)
  • ScreenBeam USB Pro Switch x's 2
  • All-in-one USB video bar
  • Touchscreen monitor

Wiring Diagram

mceclip0.png

Note: 2 ScreenBeam Pro USB Switches are required for this configuration

 

Wiring Connection Steps

On the USB Switch

  1. Connect the USB cable from the touchscreen display to the USB Switch Device 1 port
  2. Connect the USB cable from the video bar to the USB Switch 2 Device port
  3. On USB Switch 1, using the provided USB cable, connect:
    1. Host Input 1 port to the in-room PC
    2. Host Input 2 port to the USB 2.0 port of the 1100 Plus next to the power supply
  4. On USB Switch 2, using the provided USB cable, connect:
    1. Host Input 1 port to the in-room PC
    2. Host Input 2 port to the USB 3.0 port of the 1100 Plus

On the 1100 Plus

  1. Connect an HDMI cable from the 1100 Plus HDMI Out port to the HDMI Input of the MTR Controller such as a Logitech Tap 

Additional Considerations

  1. Configure the 1100 Plus HDMI Port Power Management setting to ScreenBeam USB Pro Switch
    1. This sets the ScreenBeam HDMI Out port to turn off immediately so the MTR screen can be seen on the display
    2. The ScreenBeam HDMI Out will activate upon a connection attempt from the user
  2. Consider customizing the MTR background image to include the ScreenBeam receiver name (i.e., room name)
  3. Wired presentation can be supported if by adding an HDMI cable to the 1100 Plus HDMI In port

Related Articles

Comments

0 comments

Article is closed for comments.